Motor/trade recommendation

MatD

Recruit
Thread starter
Joined
May 21, 2016
Messages
1
I have picked up a 1973 16ft fiberglass boat and freshened it up a tad. I also found a 73 18hp Evinrude and rebuilt the carb, fuel pump, ignition, etc, etc, etc. It runs wonderul. A gentlemen I know has a 1973 25hp Evinrude that also runs, but doesn't have as many new parts. His jon boat is only rated for 18hp, so he wants to trade.
Are there any differences between these motors to make the trade not worth it?
Is one easier to work on then the other?
Now that I trust my own motor, will the 7HP increase be worth it?
Thanks everyone in advance!
 

Scott Danforth

Grumpy Vintage Moderator still playing with boats
Staff member
Joined
Jul 23, 2011
Messages
53,435
Motors would be very similar to each other in terms of working on them
 

lindy46

Captain
Joined
Nov 27, 2008
Messages
3,886
Motors are about the same when it comes to working on them. If you've done all that work on the 18, you can do it on the 25. That 25 would push the 16' boat a little better, BUT you never know what you're getting into with an unknown motor. You KNOW what you have with the 18. I certainly wouldn't trade even-up if you'll be doing a lot of work on the 25. And be sure to check compression, and check the gearcase for water intrusion.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
The motors are virtually the same---except the 25hp is a souped-up version. Different pistons, cylinder head, carburetor, etc. No you can't mix & match the parts without doing them all. The 25 is faster on the right kind of boat. As for your 16ft fiberglass, it's hard to say what the difference will be. My guess is that it is marginal either way. Why don't you put the 25 on it for a test run? Then make your decision.
 
Top