motor to console wiring

DG68

Recruit
Thread starter
Joined
Jul 5, 2016
Messages
3
I've just purchased a 2004 Johnson J90PLSRR with the throttle control, no gauges or accessories came with the motor. The problem is the throttle control has three pre wired connections(assuming they are ignition, trim and tilt and low oil/overheat alarm) the cable bunch from the motor has four pre wired connections (I am assuming the fourth connector would go to an instrument cluster. The three like connectors are plugged in but the motor doesn't appear to get any power, no sounds from solenoid or anything else for that matter. If in fact the eight pin connector is for the instrument cluster would that break the ignition loop for any reason?
 

bob johnson

Rear Admiral
Joined
Feb 25, 2009
Messages
4,306
I am guessing that it would not. I would look to make sure the engine fuse is good, and to make sure the shift-neutral safety switch in the control is hooked up....

I have hooked my similar motor and controls together while the engine was on a stand, and it fired right over...obviously the gauges cluster was not connected!!!!!!!!!!!!!

other than the previous places to look, I would look for a broken wire in the start/stop circuit.....I cant remember if it is the black/yellow, or yellow.red wire!!!...I am pretty sure it is one of those
bob
 

DG68

Recruit
Thread starter
Joined
Jul 5, 2016
Messages
3
I will check that this afternoon, I couldn't imagine that it would have any effect on the ignition system. Thank you,
 

DG68

Recruit
Thread starter
Joined
Jul 5, 2016
Messages
3
Response to Bob Johnson, I thoroughly inspected the shifter and found that the neutral switch for this controller is supposed to have two tiny plastic alignment studs to orient it to the throttle control one of the studs is missing as well as one of the screws that should hold the switch in place. Thank you again.
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,332
If your motor is like my '98 Johnny, you will have the 8 pin DIP connector for the System Check tachometer. You should also have three ring connectors (black, purple, grey) for a standard tach. The third set of ring connectors (black, purple,brown/white??) will be for a trim gauge.
 
Top