Motor cutting in and out

david4702

Recruit
Thread starter
Joined
Jun 25, 2003
Messages
1
I have a 120hp Evinrude motor (late 80's)that runs smooth and quiet at idle, but after planing out, the engine will rev down then back up and repeat this for about 15 seconds. After this it will even out and run normal for about 15 seconds, and then it will start the same pattern again. The rpm drop is approx. 1200-1400 and this problem occurs continuously. Should I lose plane, I must drop down to idle for a minute or so before the engine will get the boat back on top. I've flushed the gas tank and changed the fuel filter. Changed spark plugs but noticed black deposits on them after returning. Recomendations have been from carb needs cleaning to oil injector problems to power packs.<br />Thanks for any responses
 

Kenny Bush

Chief Petty Officer
Joined
Mar 24, 2002
Messages
564
Re: Motor cutting in and out

Sounds to me like you could be dropping a coil..... But your other answers could be the problem too, but less likely..... I would however, put a can of "SeaFoam engine tune" in your gas tank. This will stabilize your gas and more than anything, decarbon your combustion chambers and pistons/rings. With the intermittent problem, I would think it is electrical.
 
Top