Hello all:
I have a MK PD V2 45, bought new in 2010, which also has a Power Drive module for use with the control fob. The boat its on is a 15 foot Lowe console model; one battery at the stern is for starting the outboard motor, and one is dedicated to the trolling motor, and the trolling motor battery was new last year. The boat was wired at the factory for a trolling motor, and there is an outlet at the bow end for that purpose. So, last week, I charged up both batteries to full charge, and the night before heading out, I did the usual full-boat systems check to make sure all was in order. I plugged in the trolling motor, heard the beep to indicate it was getting power, and I turned it on and it ran. The next morning, when I plugged it in, no power. The battery status light will not show a thing either. Later at home, I checked the battery: full charge. When I bought the MK last year, I got the MK plug and receptacle kit, and it worked great all through 2010. So, I took the plug apart and re-assembled to make sure all contacts were good, but no result. When I bought the unit, the dealer/authorized service center said there was no need for the in-line fuse since its only a 45 lb thrust motor (in-line fuse is apparently recommended for the larger 65 lb thrust motors). Under the console, I can't really tell where the fuse relay for the factory-wired trolling motor would be, so I changed out three 5A fuses to be safe. No luck.
So, any ideas?
Many thanks,
Chris
I have a MK PD V2 45, bought new in 2010, which also has a Power Drive module for use with the control fob. The boat its on is a 15 foot Lowe console model; one battery at the stern is for starting the outboard motor, and one is dedicated to the trolling motor, and the trolling motor battery was new last year. The boat was wired at the factory for a trolling motor, and there is an outlet at the bow end for that purpose. So, last week, I charged up both batteries to full charge, and the night before heading out, I did the usual full-boat systems check to make sure all was in order. I plugged in the trolling motor, heard the beep to indicate it was getting power, and I turned it on and it ran. The next morning, when I plugged it in, no power. The battery status light will not show a thing either. Later at home, I checked the battery: full charge. When I bought the MK last year, I got the MK plug and receptacle kit, and it worked great all through 2010. So, I took the plug apart and re-assembled to make sure all contacts were good, but no result. When I bought the unit, the dealer/authorized service center said there was no need for the in-line fuse since its only a 45 lb thrust motor (in-line fuse is apparently recommended for the larger 65 lb thrust motors). Under the console, I can't really tell where the fuse relay for the factory-wired trolling motor would be, so I changed out three 5A fuses to be safe. No luck.
So, any ideas?
Many thanks,
Chris