Minn Kota Powerdrive?

dannycop

Recruit
Thread starter
Joined
May 19, 2009
Messages
2
Hello im new here.
Today I bought a 70lb 55" shaft, powerdrive 24V. I took my old Johnson 12/24V off and installed this one. The female plug on the boat has two red wires and two black wires running into it. I plugged the black and red wires from the minn kota into the 24V side.
I can get the shaft to turn properly, but the motor will not do anything, and the battery check button does nothing when I press it.

What have I done wrong, any clues?

Thanks in advance.
Danny
 

simplystressed

Petty Officer 2nd Class
Joined
Mar 16, 2009
Messages
176
Re: Minn Kota Powerdrive?

Hello im new here.
Today I bought a 70lb 55" shaft, powerdrive 24V. I took my old Johnson 12/24V off and installed this one. The female plug on the boat has two red wires and two black wires running into it. I plugged the black and red wires from the minn kota into the 24V side.
I can get the shaft to turn properly, but the motor will not do anything, and the battery check button does nothing when I press it.

What have I done wrong, any clues?

Thanks in advance.
Danny

Use a voltmeter on the connections you plugged into. Make sure there is 24V being measured. Make sure you have a good charge and connections.
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Minn Kota Powerdrive?

You can start by simplifying the wiring for the two batteries. Right now you apparently have a separate pair of red and black wires going up front. That configuration was set up for motors that could run on 12 or 24 volts. Your new motor does not have that capability - it is 24 volts only. With your current wiring you are feeding the motor ONLY 12 volts. Here is what you can do to simplify this. Disconnect all four wires at the batteries. You will not use one pair so ignore one pair. Connect the other pair as shown in the diagram below. Add the jumper between the two batteries. You now have a 24 volt system on two wires going up front. Match the two wires in the troller plug to the two wires you used from the battery and go fishing.

24VTrollerWiring.jpg
 
Top