Minn Kota Power Up Relay

EKB

Recruit
Thread starter
Joined
Apr 2, 2009
Messages
1
I need a relay for a old Minn Kota Power Up outboard motor tilt unit. The tilt unit is a Minn Kota Power UP Trim & Tilt MKN-5400 which can handle a 15 to 90 hp outboard. The old relay has no part numbers on it and the paper label has disintegrated. Can anyone tell me where I can find a new or old relay? The tilt motor is a two wire job but the relay has three wires coming into it from the switch and two wires from the battery and two wires to the tilt motor.
 

Steve762us

Recruit
Joined
Aug 3, 2008
Messages
2
Re: Minn Kota Power Up Relay

I need a relay for a old Minn Kota Power Up outboard motor tilt unit. The tilt unit is a Minn Kota Power UP Trim & Tilt MKN-5400 which can handle a 15 to 90 hp outboard. The old relay has no part numbers on it and the paper label has disintegrated. Can anyone tell me where I can find a new or old relay? The tilt motor is a two wire job but the relay has three wires coming into it from the switch and two wires from the battery and two wires to the tilt motor.

Shouldn't be too hard :D

You want a relay rated for the volts & amps of the application. The two wires coming from the battery will dictate the voltage rating for the relay (presumably 12 Volts).

The lines to battery should be fused; the amp rating of the fuse will give you a start point to figure the amp rating for the relay. For example, if the fuse on the battery line to relay is 10 amps, you'd want a relay rated for more than that (the fuse should be the "weak link" in the circuit)--a relay rated for 15 amps would be a good fit.

You could even go a bit higher on the relay's AMP rating, and you'll be fine...

If the mounting arrangement looks funky, you can use wire leads to connect the replacement relay to whatever the original relay was connected to.
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Minn Kota Power Up Relay

Selecting a relay based on the existing fuse size is not the way its done. The relay must obviously have a 12 volt coil and has a very low current draw. It is the relay contact current capacity that must be carefully selected because it is those contacts that carry the high current to the motor. There are two circuits to fuse in this system. The relay coil is low current and it should be on probably a 5 amp circuit. The secondary contact 12 volt feed should have a 15A fuse or one that can handle the current draw of the motor. I'm pressed for time so I can't create a wiring and relay form factor diagram for you just now. But stay tuned if nobody else jumps in.
 
Top