? Minn Kota foot pedal quick release.

Expidia

Commander
Thread starter
Joined
Aug 26, 2006
Messages
2,374
She has this model:
http://www.iboats.com/50PD_Powerdri...0711401--**********.886981928--view_id.274460

Once I install the quick release I also want the wires to be quick release. I know for the power wires to the battery I can use a Marinco plug.

But is there a quick release plug that I can splice in to be able to separate the foot pedal with it's long wire from the motor. I don't want to drag the foot pedal and wire around when I remove the unit. I'd like to be able to toss the pedal and wire into a locker and put the Minn Kota in the trunk.
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: ? Minn Kota foot pedal quick release.

The foot pedal on a Power Drive already has a plug on it. Disconnect it and stow the pedal.
 

Barnacle_Bill

Admiral
Joined
Feb 8, 2004
Messages
6,469
Re: ? Minn Kota foot pedal quick release.

You can always add the co-pilot now or later. That way you can keep the pedal stored all the time and just drag it out if the battery in the xmitter goes out.
 

Expidia

Commander
Thread starter
Joined
Aug 26, 2006
Messages
2,374
Re: ? Minn Kota foot pedal quick release.

thx for the responses. Ya, I saw those transmitters but they look like they cost $150!

Good to hear the pedal has a plug. The boats not at my house yet so I couldn't check it out for a way to disconnect it..
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: ? Minn Kota foot pedal quick release.

The older Power Drives had a flat connector. The new V2 Power Drives have a smaller round connector.
 

Expidia

Commander
Thread starter
Joined
Aug 26, 2006
Messages
2,374
Re: ? Minn Kota foot pedal quick release.

The older Power Drives had a flat connector. The new V2 Power Drives have a smaller round connector.

Yep, checked the rig out on my way home from the lake and disconnected the "round" connector.

This short time previous owner did not know much about electronics cause he said he could never get the Garmin to work. He said he thinks someone that knows these units can get it working, we shall see.

I can believe this from him because he didn't know enough to change a burnt out light bulb. I hooked it up to my car and saw the bulb was blown. Luckily
he amazingly had another one in the bottom of his tool before I was doing the 2 hour drive home and it was getting dark already. He said he thought the light issue was a blown fuse in his truck.

Also, even though the boat came with a troller plug it was only crimped to the motor and one crimp had already let go and the other fell out when I grabbed it. So they never released the wires and kept the foot pedal in the locker attached and the locker cover was crimping the wires and almost split them through.

If anyone knew about this stuff it was certainly not the way to present the boat if one was trying to sell it.

It's easy to see where marinas clean up on labor charges because so many boaters no nothing about how to add accessories to their rigs.
 
Top