Minn Kota controller going bad?

iowabucks

Recruit
Thread starter
Joined
Apr 1, 2009
Messages
4
Hey everyone, new on the forums here.

I have a question about my Minn Kota 35Ta trolling motor. This is a small motor that my brother and i keep for fishing farm ponds. We just take the trolling motor and battery to a couple different farm ponds we know of and use the owners johnboats. Works out pretty good. We have used it for a good 10 to 12 years.

I have noticed lately a reduction in power. It has 5 speeds and there is no noticable difference in sound from 2 to 3. It doesn't seem like the prop is spinning as fast as it used to at full speed. The handle has spun around a little and the numbers don't match up with the real speed at all. I'm hoping the outside of the handle has spun a little instead of the controller itself being bad. I have had it apart a few times to replace a few hinge and bracket parts. Also had the control box open to check to see if the controller had spun. Everything looked good inside there.

Does the controller ever go bad on these motors and do these symptoms sound like the controller?

Is there any other thing that could make it lose power?

I may take the motor cover off to check the brushes.
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Minn Kota controller going bad?

If it's a very old motor the speed is controlled by "speed coils" which are really wire wound resistors connected in various combinations. The controller is merely a switch on those motors so if one or more of the speed coils was bad (open) that speed wouldn't work. So there really is no slowing down. Have you had the battery load tested to make sure it is not headed for "battery heaven". Even though your are charging it, it may not be holding a charge like it did when new. It must also be recharged immediately after each use. Don't wait until the next time you want to use it to recharge it.
 

iowabucks

Recruit
Thread starter
Joined
Apr 1, 2009
Messages
4
Re: Minn Kota controller going bad?

I talked with a Minn Kota tech today and he said it could be the switch. It is definately off one number on the handle. (Speed 1 is actually off now. Grip is on the handle straight and switch is in the control box straight and in the groove) He told me how to wire it straight to the motor and there is a small difference it top speed "hum". With it wired up normally I'm only getting 11.44v to the motor. Shouldn't it be 12v?

Of course it's old enough that they don't make those parts anymore, but we can put a new bottom to the control box and put in a newer style switch. Only $20 for those parts, so i may give that a try first. If it doesn't help, i may check the motor to see how the brushes are.

I had they battery tested under load last year, and it's only two years old. Maybe i'll have it done again just to be sure.
 
Top