I have a question. My bass boat features an on board charger. I have a 24 v battery set up for trolling. There is a switch for 12 or 24 v. There is 2 circuit breakers wired in back at the batteries (40 amp). I went to replace the 3 prong recepticle and put in a Marinco. There are 3 wires (red, orange, black) to hook up. I assume the red or orange is for 12 and 24, and the black is neg. I wired them into the Marinco as they were on the original. My new motor only has a black and a red lead. The old one had 3 wires. The new motor is a 24 v Maxxum 70. Can anybody help me out here on how I should wire this new set up and still be able to use the onboard charger and not fry my new motor? The switch on my bow has a 12-2 setting(left), a 12 setting (mid) and a 12/24 setting (right). This is the Charge/Run switch and the motor plugs into the recepticle on this. I have a 1987 Skeeter and this was the factory set up.
Thanks!!
Thanks!!