merc 1976 1150 115hp starting problem

ellejosh33

Recruit
Thread starter
Joined
May 10, 2009
Messages
4
I have a 1150 115hp model year 1976. I have replaced the battery cleaned all connections and it is turning the fly wheel slowly. The battery is fully charged.
I took off the starter and had it tested. It is showing 50 amp then a drop to 30amp. Is this normal or does the starter appear to be low/bad.
I did try to start it directly by hooking up jumper cables then cranking with the same results. Also took out the new plugs and sprayed oil in all cylinders and ran through before putting plugs back in.
This motor sat for 2 to 3 years outside. It was covered but ....
I am new to boat engins and want to learn this not just take it to a shop. any help is greatly appreciated and thank you in advance.
 

Yepblaze

Lieutenant Commander
Joined
Jun 1, 2001
Messages
1,686
Re: merc 1976 1150 115hp starting problem

Try jumping it from a known good car battery if needed. Sometimes if a deep cycle battery is used they can turn slow.

Keep cranking and choking fully. They can take a lot of each to get going.
 

ellejosh33

Recruit
Thread starter
Joined
May 10, 2009
Messages
4
Re: merc 1976 1150 115hp starting problem

I have choked and cranked as well as tried the car battery.The battery is new and I am keeping it fully charged. The fly wheel is turning very slowly. It will at times stop then turn a little more. this is with any power source connected. With the plugs out it will spin but not at a high speed. I suspect the starter. Is 50amp initial then a drop to 30amp normal or low for this model??
 

cell

Petty Officer 1st Class
Joined
Apr 16, 2009
Messages
208
Re: merc 1976 1150 115hp starting problem

By pass the batter cables,and jump it at the starter relay.If it cranks better then the cables should be replaced.
 

Yepblaze

Lieutenant Commander
Joined
Jun 1, 2001
Messages
1,686
Re: merc 1976 1150 115hp starting problem

It sounds like you may need to pull the starter and repair or replace it.
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,332
Re: merc 1976 1150 115hp starting problem

Make sure the ground cable from the starter to the cowling support is good. That starter is mounted in rubber sleeves, and must have a good ground cable.
 

ellejosh33

Recruit
Thread starter
Joined
May 10, 2009
Messages
4
Re: merc 1976 1150 115hp starting problem

I will bypass again and then re clean and check the ground and all wire and connections. If this does not work I will replace/rebuild starter and then post results.Thank you to all.
 

gunnerb

Cadet
Joined
Jun 20, 2011
Messages
9
Re: merc 1976 1150 115hp starting problem

I had the same problem, on the same engine. I put on a new starter, and solved the problem.
 
Top