mecury tilt/trim pump ?

[Vision91]

hello its me again with another quick? my 12v motor on my trim/tilt pump went out the brushes are completly gone and a wire is broke or ripped. my question i have is can i buy any new pump or does it have to be one that puts out the exact psi mine does which is around 4500 psi..i could b wrong on that and it might be 450 psi but here is a picture of one which is the same one i have


forgot to mention its used on a 1972 mercury ob 1150...yea i know the pump is overkill for this engine but it came with the boat

 

[Chris1956]

Re: mecury tilt/trim pump ?

I am confused by your posting. You need to replace the PTT pump motor with an exact replacement. If you can get a used PTT pump and resevoir, of the same type you already have, you can use that. The inline 4 and 6 cylinder Mercs for most of the 70s used a pump/resevoir like in your picture.

 

[chum1]

Re: mecury tilt/trim pump ?

you can also solder in new brushes per service manual

 

[Vision91]

Re: mecury tilt/trim pump ?

well my issue is im not sure if just any brushes will work and im not sure who made this pump or the 12v motor

 

[chum1]

Re: mecury tilt/trim pump ?

here is another option, there are also some different motors listed in description, not sure if this is the exact one u need, research will probably be in the cards for this application

http://www.ebay.com/itm/NEW-TILT-MOTOR-TRIM-67914A2-76395A2-18-6763-6217-10814-/190577858359#vi-desc

 

[Chris1956]

Re: mecury tilt/trim pump ?

You should be able to get brushes from merc or Crowleymarine web site. Aftermarket replacement motors and resevoir assembly may be avail. It would help if I knew what you were looking for.

 

[Vision91]

Re: mecury tilt/trim pump ?

im looking for top cover on the motor that haves the brushes on it or the complete housing with the magnets in it ill take a picture and post it in a few gotta find the camera first

 

[Chris1956]

Re: mecury tilt/trim pump ?

Check and see if ARCO makes an aftermarket Motor and resevoir. They used to.

 

[merc850]

Re: mecury tilt/trim pump ?

The brushes failed on mine last year and a dealer had the end cap with brushes attached (old cap here for example) but you have to use silver solder to attach,the cap also has a thermal cutout in it.