MC-1 transom + cork gasket, to seal or not to seal?

K

kenny nunez

Captain
Joined
Jun 20, 2017
Messages
3,290
In the event that bilge water should get high enough to enter the lower mounting bolt holes then galvanic action will begin to eat up the anodic lower bolts and the studs. I have seen enough of that where the lower studs were almost eaten away. That is when the outer transom gasket starts to let water seep under it. So a little sealer around the mounting hardware will prevent that from happening.
 
Bondo

Bondo

Moderator
Staff member
Joined
Apr 17, 2002
Messages
70,957
kenny nunez said:
In the event that bilge water should get high enough to enter the lower mounting bolt holes then galvanic action will begin to eat up the anodic lower bolts and the studs. I have seen enough of that where the lower studs were almost eaten away. That is when the outer transom gasket starts to let water seep under it. So a little sealer around the mounting hardware will prevent that from happening.
Click to expand...
Ayuh,...... Or from the inside, from a very wet bilge,...... ;)
 
You must log in or register to reply here.
Top