Evening fellers,
Welp, I've got this incredibly frustrating bellows job just about knocked off (this is my first time).
I've been through every damn thing a guy could go through getting this baby patched up. I've bored and tapped for the new shift cable (was done previously, but brass fitting had to be drilled out).
Anyway, got everything buttoned up down to the dang shift cable. I've got a piece of wire through where the old cable went to pull the new housing through, bellows over the metal end of the outer cable housing, but the thing refuses to pass through the transom.
Anyone got some tricks or tips? I'm just about at my wits end with this thing.
Welp, I've got this incredibly frustrating bellows job just about knocked off (this is my first time).
I've been through every damn thing a guy could go through getting this baby patched up. I've bored and tapped for the new shift cable (was done previously, but brass fitting had to be drilled out).
Anyway, got everything buttoned up down to the dang shift cable. I've got a piece of wire through where the old cable went to pull the new housing through, bellows over the metal end of the outer cable housing, but the thing refuses to pass through the transom.
Anyone got some tricks or tips? I'm just about at my wits end with this thing.
Last edited: