LOW RPM"s UNDER LOAD

richvuke

Recruit
Thread starter
Joined
Jun 2, 2010
Messages
2
I have an early 80's Mercury outboard that starts and idles very well. On the test bed the motor runs to full RPM, however when the motor is in the water under load the motor RPM?s are very low ( 1000 -1500). Removing the prop again the motor run well all the way to full RPM?s. I introduced extra gas into the carb, thinking the problem was fuel flow when the motor was under load (i.e. prop on and in grear) and the engine chocked on the extra gas. Compression on both cylinders is in the 130 PSI range. Carb is not out-gassing when running so I?m thinking the reed valves are OK. Spark plugs appear to be firing hot and are not carboned up. There are no signs of overheating. I have not checked timing or the condition of the points. I confused as to where to start as the engine starts and idles so well and seems to be getting enough gas. Also the engine seems to be running fine when the prop is not engaged or in the water. The engine and it?s history are not know but it appears it was not been run for the past few years. Please help with some ideas of where to start. Thank you in advance
 

Lrider

Chief Petty Officer
Joined
May 19, 2010
Messages
631
Re: LOW RPM"s UNDER LOAD

is it pumping water

when was the last time the lower was serviced

Might just need some TLC
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,332
Re: LOW RPM"s UNDER LOAD

The motor could be over propped. What HP motor? What Pitch prop, what kind, length, weight of boat?
 

richvuke

Recruit
Thread starter
Joined
Jun 2, 2010
Messages
2
Re: LOW RPM"s UNDER LOAD

Thanks you all for the quick responses, I will attempt to respond to all the questions as best I can. The lower unit fluids have been replaced and all seems the be fine, no binding or indications that the motor loading is caused by the gear train. When the motor is in gear, you can turn the prop and all seems free between the prop and the motor. As to prop size I compared the current prop with a prop on a new 20 HP unit and they appear to be very similar. I also used a couple of the prop selection programs available on the net, to get the RPM reductions I see does not appear to be possible with the nominally available props. From the best I can find out the current prop is a 10-1/2 x 11P. The boat is a 14? Bass tracker. I an guessing the weight of the boat to be in the 800# range when loaded. Similarly equipped boats seem to run in the 18 -20 MPH range, mine can not get above 6 -7 MPH. Water flow is fine and the boat does not over heat even after long runs. Not much more I can add that might be helpful.

I did try moving the gas/air mixture screw from its initial position w/o luck. The initial position was 1 & ? turns off of the bottoming out position. The motor performance seems awfully good considering I moved the screw from fully closed to more than 3 full turns out without an appreciable difference in performance. The motor did stutter and finally die only when the screw was with in ? turn of the closed/bottom position. I tried full to get full RPM?s at multiple setting of the gas/air adjustment screw without success, i.e. RPM?s never exceed 1500 for a settings between ? turn off fully closed to 3 full turns out from fully closed.


Please help as the grandkids want to go fishing.
 
Top