Limp mode

[unbtabl]

Ok, just run the timing light like on an automobile engine?

 

[alldodge]

Yes, same way
and while your at it check base timing

 

[unbtabl]

Yes, same way
and while your at it check base timing

Sorry about the delay in questions. I took the boat back to the shop that was supposed to have fixed this isssue last summer. It’s been there 4 weeks and the only info that’s been relayed to me from his receptionist is that the tps is not reading. He said he did a voltage sweep to make sure the tps was good. I’m frustrated because this is the only info I’ve gotten in 4 weeks. What other sensors would cause the tps to shut fuel down? Map?

 

[alldodge]

You should have codes with no TPS sweep. Not liking what your dealer is saying. Most the sensors run off a 5V reference voltage. Checking the TPS is easy enough with a ohm meter

 

[unbtabl]

You should have codes with no TPS sweep. Not liking what your dealer is saying. Most the sensors run off a 5V reference voltage. Checking the TPS is easy enough with a ohm meter

Sorry, I may have phrased that wrong. He hooked it up to his computer. No codes. But, tps isn’t reading. I checked it as well before I dropped it off. No codes were showing. I’m assuming the TPS did sweep considering he said the TPS was good. I don’t get to talk to him directly.