I have an electrical problem with my ski boat (1990 Chaparral SL1900) that I can?t seem to figure out. Since I just completely rewired my pontoon boat I thought that this would be a pretty easy fix, but it really has me frustrated.
The stern light will light when the switch is in the ?anchor? position but will not light in the ?Navigation? position (the bow light works fine).
I removed the socket and got the following results with my volt meter attached to the wires:
Switch on off: 0 volts, Anchor: 12 volts, Nav.: 12 volts. I?m getting 12 volts to the socket.
When I insert the bulb and check the voltage on the wires going to the socket the voltage in ?Nav.? position drops to 0 volts but stays at 12 volts in the ?Anchor? position. The load of the bulb seems to be causing the voltage to drop to 0 only when the switch is in the ?Nav.? position but stays at 12 volts in the ?Anchor? position. I replaced the bulb with the one from my pontoon boat and got the same results.
A mechanic at a local marina told me that it had to be a grounding problem so I ran a wire from the socket directly to the negative terminal of my battery and got the same results as above.
The other thing that makes no sense to me is that when I check the wires at the socket with an ohm meter it shows resistance (open circuit) in both ?on? positions and no resistance (direct short) in the ?off? position. I would think that it should be the opposite.
Has anyone had this problem before or any ideas on what is causing it? I realize that my problem may be in the switch, but I don?t understand how the switch can cause the voltage drop at the socket.
The stern light will light when the switch is in the ?anchor? position but will not light in the ?Navigation? position (the bow light works fine).
I removed the socket and got the following results with my volt meter attached to the wires:
Switch on off: 0 volts, Anchor: 12 volts, Nav.: 12 volts. I?m getting 12 volts to the socket.
When I insert the bulb and check the voltage on the wires going to the socket the voltage in ?Nav.? position drops to 0 volts but stays at 12 volts in the ?Anchor? position. The load of the bulb seems to be causing the voltage to drop to 0 only when the switch is in the ?Nav.? position but stays at 12 volts in the ?Anchor? position. I replaced the bulb with the one from my pontoon boat and got the same results.
A mechanic at a local marina told me that it had to be a grounding problem so I ran a wire from the socket directly to the negative terminal of my battery and got the same results as above.
The other thing that makes no sense to me is that when I check the wires at the socket with an ohm meter it shows resistance (open circuit) in both ?on? positions and no resistance (direct short) in the ?off? position. I would think that it should be the opposite.
Has anyone had this problem before or any ideas on what is causing it? I realize that my problem may be in the switch, but I don?t understand how the switch can cause the voltage drop at the socket.