Leaking Gear Case

Rambo23

Cadet
Thread starter
Joined
Dec 13, 2015
Messages
11
Hi,

I've been battling leaking gear case drain screw and milky gear oil. I finally got the screws and new washer and got that sealed. However just recently I noticed milky gear oil leaking out of one of the small holes in the gear case that normally would just have water coming out of it when you raise the motor out of the water. What does this mean?

1968 Johnson 20hp
 

Attachments

  • image.jpg
    image.jpg
    191.2 KB · Views: 0

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
That may well be normal on that motor.------Picture is not very clear but you might want to install a stainless cotter pin for the propnut.
 

Rambo23

Cadet
Thread starter
Joined
Dec 13, 2015
Messages
11
That may well be normal on that motor.------Picture is not very clear but you might want to install a stainless cotter pin for the propnut.

It's definitely gear oil and it's light green and thin viscosity were as new gear oil is thick and dark green. I don't think that could be normal as I'm losing gear oil that is water contaminated. However I'm not an expert and don't even known what that hole does. Please explain. I have a cotter pin on there but it blended in on the picture for some reason.
 
Last edited:

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
That hole is a drain hole for a casting cavity.------Prevents the lower unit from cracking in cold climates.------No point in arguing to me about normal or not.--------You pressure test the gearcase to find leaks if any exist !
 

Rambo23

Cadet
Thread starter
Joined
Dec 13, 2015
Messages
11
Definitely gear oil that's leaking it has the distinct smell. Where can I buy or how do I make a pressure tester. I've heard about people making them out of mity vac cooling system testers.
 
Last edited:

AlTn

Commander
Joined
Mar 9, 2010
Messages
2,813
mityvac makes a gauge that is a vacuum/pressure gauge combo, can't recall the model no.,,,,the screw in portion of a johnson/evinrude lower unit oil pump will work for the fitting< may require an oring for a good fit >...pressure test at 4 psi...8 or so...then 12 ...you turn the drive shaft at the same time trying to mimic real conditions on the seals
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Considering where it's coming out of I would say the shift shaft seal needs to be replaced pretty common
 

AlTn

Commander
Joined
Mar 9, 2010
Messages
2,813
not to remove the gearcase..you may need an impact driver for the 6 phillips head screws holding the gearcase halves together...some 3M 847 Rubber and Gasket adhesive for resealing the halves...depending on how you remove the shift shaft bushing to replace the seal, you may be time ahead to get a new bushing for the reinstall...take the time to examine exactly how oil can be coming from that hole before reassembling the gearcase
 
Top