Knocking sound 1996 8hp Jonson

Screaming Seagull

Recruit
Thread starter
Joined
Oct 22, 2017
Messages
1
Hello everyone, I'm new to this forum so I'm hoping you can help. My '96 8hp Jonson (J8RLEDS) had low compression so I replaced the pistons and gaskets. Now that it's back together, it's making a knocking sound at idle and in gear. Sound appears to be coming from the crankcase

What did I do wrong?
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Take the lower unit off and see if the sound continues. How were the bearings in the motor? I believe the lower crank bearing has a snap ring on it did you make sure that was on?
 

raczekp1

Lieutenant
Joined
Mar 30, 2010
Messages
1,327
while you split crankcase did you notice 1 small hole per each cylinder wall? some motors have relif holes to lower compresion,
this cnocking noice is becouse you put in wrong side conn rod caps or upper bearing is not match in right place
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
Pull one plug wire at a time and see if the knocking sound changes.
 

Bluestream

Petty Officer 1st Class
Joined
Sep 28, 2010
Messages
299
Did you check the connecting rod bearing s when you have the cases apart? Was the motor ran at 100/1 in the past?
 
Top