Kill Switch Help - Wiring - Its not the switch

Rollins

Recruit
Thread starter
Joined
Aug 25, 2011
Messages
2
My Lanyard Kill Switch is not working on my 1990 Ranger 395vs w/ a Yamaha 225. I initially thought that my kill switch was bad so I replaced it. Now it still will
not kill my boat motor when pulled. I tried touching the 2 wires together totally bypassing the switch and it still will not kill my motor. The motor also still runs
when the wires are not touching. The wires coming out of my ignition switch are as follows.

2 Black Wires
1 White Wire
1 Yellow Wire
1 Red Wire
1 Brown Wire

One of the black wires go to my kill switch, and the white wire goes to the kill switch. All of the wires look original in my throttle box (it doesnt look like anyone
hot wired anything to bypass the switch.) What is my next plan of action? Do I need to look at the back end of the boat wiring?

Thanks All, Im just trying to be safe on the water for myself and others. Any advice would be appreciated.

Rollins
 

brianvolt7

Chief Petty Officer
Joined
Jun 7, 2008
Messages
423
Re: Kill Switch Help - Wiring - Its not the switch

Rollins,

You may want to try the Yamaha forum with this question as well.
 
Top