Just bought a new marine 1 wire alternator

ixxbigdxxi

Recruit
Thread starter
Joined
May 23, 2011
Messages
4
Glad I posted here haha. Per the post I just made a few minutes ago, you advised no car parts on a boat because they have to be marine rated and such. So went on ebay and found a good priced 105 amp marine alternator but it is internally regulated rather than the old one I took off. Once this one comes in, what do I need to change? Doesn't seem like any major changes other than removing the regulator and just make sure the alt is grounded and BAT cable connected. Is that pretty much it? Seems like this set up is a whole lot easier!
 

Brentathon

Petty Officer 1st Class
Joined
Dec 29, 2009
Messages
399
Re: Just bought a new marine 1 wire alternator

I just replaced my alternator; the old one was a 2-wire, and the new one I installed had the red/purple & purple leads (voltage sensing & excitation). I'm not sure if one style is "newer" or not, but this 4-wire seemed to be the one called-out for my engine, so, everything seems fine.
When my 2-wire was installed, the 2 leads were simply taped up with some electrical tape, and not used.
 

Don S

Honorary Moderator Emeritus
Joined
Aug 31, 2004
Messages
62,321
Re: Just bought a new marine 1 wire alternator

Doesn't seem like any major changes other than removing the regulator and just make sure the alt is grounded and BAT cable connected. Is that pretty much it?

Hard to say, what are we working on?
 
Top