Jonson Outboard 250 hp primer lines?

jerry 5566

Cadet
Thread starter
Joined
Nov 12, 2015
Messages
7
On the bottom of the block under the carburetor is a primer line next to a valve (pcv?) that is not connected. Does anyone know where this is supposed to connect to? model number j250 vz sss 2000 model
 
Last edited:

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
I guess I meant for you to post the model # and a pic of the unhooked fuel lines
 

jerry 5566

Cadet
Thread starter
Joined
Nov 12, 2015
Messages
7
Primer line at bottom of block next line coming from vro pump the line is about 10 ' long pict not real good but will get beter one as soon as we see sunshine merry christman to all that looks at this post thanks for the help
 

Attachments

  • FullSizeRender.jpg
    FullSizeRender.jpg
    75.5 KB · Views: 0
Last edited:

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
The " pcv " may well be the " pulse limiter " for the VRO fuel pump / oil mixing unit.----There is a wee oil line that goes from the bottom to the upper bearing.----Is this a V-8 model?
 

jerry 5566

Cadet
Thread starter
Joined
Nov 12, 2015
Messages
7
no this is a v/6 model I found in service manuel that the valve is pulse limiter for the vro but doesn't mention anything about the small line under the pulse valve as to where it goes
 

Faztbullet

Supreme Mariner
Joined
Mar 2, 2008
Messages
15,938
There are 2 lines that come off small nipples on crankcase, the bottom one goes back to top of block to recirculate unburnt fuel oil to top bearing, the upper one follows the bottom one but only half way as it is a vent for bottom bearing, this was a update to make em idle better.
 

jerry 5566

Cadet
Thread starter
Joined
Nov 12, 2015
Messages
7
Thanks I will look today to see it I find the two small vent that you are talking about
 

jerry 5566

Cadet
Thread starter
Joined
Nov 12, 2015
Messages
7
did look was not at top but at bottom there is two small outlets one of the vents is attached to the top outlet by what spears to be vent hose the that I'm questing shown in pint must be a vent hose problie jut need to cut aversive amount of the rubber pipe and discard
 
Top