Jon boat wiring question

jwnine

Recruit
Thread starter
Joined
May 13, 2009
Messages
1
I just recently purchased a 12 foot jon boat and trolling motor. Can you wire the trolling motor, fish finder, and running lights directly to a deep cycle battery? The motor currently has alligator clips which I would like to get rid of. What kind of fuses and switches should I use?
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Jon boat wiring question

Everything you mention requires 12 volts to operate so if the deep cycle battery is all you have for power, that's where things get connected. It is preferable to have a fuse or circuit breaker panel but in-line fuses work as well. They just clutter up the wiring a bit. As for the trolling motor alligator clips, you can cut them off and splice a two terminal plug onto the wires. You then add the mating receptacle to the front of the boat (or back if you have a transom mount motor). That receptacle gets wired to the battery as well but must include a circuit breaker on the POS post of the battery.
 

Hanr3

Seaman
Joined
Apr 20, 2008
Messages
71
Re: Jon boat wiring question

You can wire each directly to the battery.
Attach the negative directly to the battery for each.
Put your circuit breaker between the trolling motor and battery on the positive side, and yes you can cut off the aligator clips and crimp on ring terminals. When your not using the boat, disconnect the ring terminals from the battery.

For the fishfinder, most require a 1 or 2 amp fuse. verify yours.
 

2 Eagles

Petty Officer 1st Class
Joined
Apr 4, 2011
Messages
206
Re: Jon boat wiring question

Hope this helps.
 

Attachments

  • 12v System.jpg
    12v System.jpg
    47.1 KB · Views: 0
  • 24v System.jpg
    24v System.jpg
    53 KB · Views: 0
Top