Johnson V4 years compatibility?

gr8_lakes

Recruit
Thread starter
Joined
Jun 1, 2006
Messages
5
First off, sorry. I'm sure this has been asked a million times. But, I've been searching for two days and can't find anything.
I have a 1997/98 Johnson 90 hp. I have a chance to pick up a running powerhead for an 85 Johnson from the late 70's.

Will the block exchange? Any other parts?
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
You may need to know the spline configuration on the top of the drive shaft vs the bottom of the crank... Keep in mind that the 85 hp engines up through 1978 were only 92.6 cubic inches, vs the engine that you currently have. (99.6 cubic inches.) Older than 78 and the blocks have only one thermostat and these won't fit.
 

bob johnson

Rear Admiral
Joined
Feb 25, 2009
Messages
4,306
there were two 90 hp engines available up to 1998 from J/E....once was a crossflow like the 85 hp, the other was a special 60 degree block looper, which I am sure wont fit....the crossflow.....not sure if it will fit...

bob
 
Top