Johnson V4 90hp

vortec59501

Recruit
Thread starter
Joined
Jul 20, 2016
Messages
3
Bought a boat last week and test drove it and it ran fine. Brought it to a local reservoir today and ran it for awhile but when i was crusing at 30mph it acted funny slowly died, and stopped. When it came to a stop it smoked some and when i tried to start it it acted like it was on a dead battery but the battery was fine. It barely turned over for every couple seconds. Like it would turn once, and pause a couple seconds then it would turn over again. Any help would be greatly appreciated im a girst time boat ownert so im clueless. Its a Johnson 90 V4 not sure of the year.
 

interalian

Commander
Joined
Jul 23, 2009
Messages
2,105
Sounds like it overheated. When was the last time it got a new water pump? Could you see the water indicator working? Post your model number.
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
Welcome to iboats
Some V4 90hp have an oil premixing system, others you have to mix the oil in the gas. Do you know which yours is?
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
Sounds like you were headed for a severe overheat lockup. You did not hear an overheat (hot) horn? Once an engine overheats, the pistons swell in the crankcase, eventually expanding just enough to lockup up inside each cylinder. If this is what is happening, it's a pretty severe problem. You should borrow a laser temp gun and see just how hot your engine gets next time you run it. Be careful not to damage it further, if in fact, this is the problem. The telltale nozzle spray indicates the pump is working, but does not insure that the powerhead water is not circulating through the block and won't internally overheat.
 

Faztbullet

Supreme Mariner
Joined
Mar 2, 2008
Messages
15,938
Break out the wallet as a service manual and rebuild is in your future....
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Your story is so classic. The water pump suddenly quit working (probably spun a hub). At any rate, the powerhead overheated to the point of severe damage. This also demonstrates how worthless those overheat horns are. The pistons overheated to the point of almost melting so quickly that the block didn't have time to get hot enough to set off the alarm. Then when it quit, and sat there smouldering. Probably also burned up the glorious overheat sensor as it sat there smoking.

As somebody said, break out the wallet. At the very minimum, you need all new exhaust gaskets and head gaskets (and water pump). When you get the exhaust covers off, you will be able to see the piston skirts and any scoring they may (probably) have.

Been there, seen that oh so many times.
 
Top