I have a question about assembling the the lower unit/ mid section to the power head. In the mid section coming down from the power head are three lines. One is the forward/neutral shaft, the other is a short shiny tube and last is a copper tube that is long and reaches to the lower unit itself. Does the copper line sit inside the plastic impeller housing?
One more question, this deals with the gear assembly in the lower unit. In between the ring gear and the pinion gear there is a thrust bearing and washer that butts up between the ring gear and gear housing. The washer is flat on one side and has a small taper on the other. Does this washer face the flat side to the thrust bearing or the tapered side? Thanks for any help.
One more question, this deals with the gear assembly in the lower unit. In between the ring gear and the pinion gear there is a thrust bearing and washer that butts up between the ring gear and gear housing. The washer is flat on one side and has a small taper on the other. Does this washer face the flat side to the thrust bearing or the tapered side? Thanks for any help.