Johnson Starting problem

Kaner

Recruit
Thread starter
Joined
Jul 19, 2003
Messages
1
Howdy.. I have a 2001 Johnson 135 outboard with a starter motor that doesn't kick up and engage the flywheel. Problem occurred suddenly as opposed to gradually. <br />Batteries are both good (12.6 volts). Bendix spins, but not fast enough to lift the upper rotor. No corrosion evident anywhere. <br />When trying to start, I put a voltmeter on the starter. I saw about 8.5 volts. I wasn't sure how to determine if I might be losing the voltage in the solenoid, but I am obviously losing voltage somewhere. (I had the starter bench tested and it is good.) Out of ideas. Any thoughts? Thanks in advance. Tim
 

ob

Admiral
Joined
Aug 16, 2002
Messages
6,992
Re: Johnson Starting problem

kaner ,Check and recheck to insure that your battery posts are clean and cables are tight.Also insure that the large cable leading to and from the solenoid are the same.You can try bypassing the solenoid with a suitable jumper cable and see if starter motor will engage bedix.Be carefull around flywheel when performing.<br />Also insure that the bedix shaft is not in need of lubrication and that the ground cable on the engine block is clean and tight.
 
Top