johnson qd-19 throttle

frmach

Cadet
Thread starter
Joined
Feb 26, 2009
Messages
12
on my 58 johnson qd-19 the cam follower does not move enough to open and close throttle.
 

frmach

Cadet
Thread starter
Joined
Feb 26, 2009
Messages
12
No, is there any other things that move the throttle other than the cam ?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Motor has to be in gear to get full throttle.----Is the plastic pin at the bottom of the towershaft in good condition ?
 

frmach

Cadet
Thread starter
Joined
Feb 26, 2009
Messages
12
I have tower shaft disconnected and flywheel removed. Moving cam by hand. linkage to carb seems ok but not enough travel
 

frmach

Cadet
Thread starter
Joined
Feb 26, 2009
Messages
12
Can I assume that the carb butterfly shaft should rotate 90 degrees?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
I would say so.----I can look at QD models here but can not see what is wrong with yours.
 

frmach

Cadet
Thread starter
Joined
Feb 26, 2009
Messages
12
Figured out the problem, The cam was mounted on backwards and upside down.
Thanks for the help and now i can get back to the other problems.

Thank you
 
Top