Johnson J5RCIC tell tale problem

Ikikoloa

Recruit
Thread starter
Joined
Jul 28, 2016
Messages
1
I have acquired a Johnson J5RCIC 4.5 hp outboard. There is no water coming from the tell tale. I have checked the impeller and it looks great, and I do have water that spits from the exhaust baffle but no water from tell tale. I have tried using a wire and cleaned some blockage but still nothing. Does anyone know what I can do?
 

TrueNorthist

Petty Officer 1st Class
Joined
May 16, 2012
Messages
229
Trace back to the elbow on the exhaust cover, that's where it is most likely blocked. Remove the hose and fish it out with a stiff wire or something, then blow out the hose. If still blocked then the cover will have to be removed and all the crud scraped out. If all else fails try compressed air, but that is not a permanent fix and may cause other problems.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
I'm pretty sure there is no tell tale on that motor. Is it overheating? Spray coming out of the small ports should indicate water is getting up to the powerhead -- either get an infrared sensor (look for maybe 120-130F at idle in the lake or a test barrel), or check the head with your hand. If it's too hot to touch, it's too hot. BTW, if I'm checking an impeller, I'm normally replacing it, but your call. If you take it apart again, and if in doubt about circulation/cooling, you can push some water up the tube with the l.u. off (motor not running, of course) -- flush it out.
 
Top