Johnson Evinrude 225hp 2004 Tilt wont go right up

johndale

Recruit
Thread starter
Joined
Jan 10, 2016
Messages
2
My tilt wont go right up. electronic button working only so far then all stops. I can manually release the screw and push the engine up and re-tighten. Then use the button to electronically move it down but then when pushing the up button again, it only goes so far again. So it wont sit right out of the water.
I had a steering cable go in the summer and have replaced it now, but there was a lot of torque going on as it sent the boat into a pirouette. so could something have happened somewhere ?
 

tommarvin

Ensign
Joined
Nov 22, 2015
Messages
999
Check the oil level in the trim tilt motor first. Check and see if anything is bent from the steering cable going out. Can you manually move the engine up past the spot it stops with the t&t motor, and down without any problems.

Is any oil leaking out of the seals of trim or tilt rams, you should see it with your eyes. Hey is the switch broken or going out?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Souns like you rotated the tilt tube.---On that tube there is a tilt limit switch cam.----Find that cam and adjust it till you are happy again.----May not even require any tools.
 
Top