Johnson Carburetor issues

Status
Not open for further replies.

NMORINROY

Recruit
Thread starter
Joined
Aug 7, 2013
Messages
1
Hello everybody! im new here and heres why. I have a 1963 40hp johnson super sea-horse. Me and my grandfather have diagnosed it down to the carb. the bowl will fill and the motor will start but the needle valve won't stop the flow of fuel into the bowl. gas is literally spilling out of the carburetor when we start it and it will run on a very high idle and then the engine floods out . I was looking at the carburetor kits but I was wondering if anyone had the same problem and what you did to fix it. Im trying to narrow the faulty parts down to prevent buying a whole new carb. Anyone have suggestions?
 

nwcove

Admiral
Joined
May 16, 2011
Messages
6,293
Re: Johnson Carburetor issues

welcome to iboats! not likely any reason to buy a new carb, just get the kit ....and float. if the kit doesnt include it. clean the carb properly , install the parts from the kit, and you should be up and running.
 

Arlan Jay

Cadet
Joined
Jun 28, 2014
Messages
13
Im haven the same problem on my 85HP v4 Johnson. The fuel is just pouring out of the lower carb. even after a rebuild of the carb. It's like there is way too much fuel getting to the carbs and the engine can't keep up. What does anyone know about this?
 

itsaboattime

Senior Chief Petty Officer
Joined
Jul 4, 2007
Messages
791
Welcome to iboats!
The float in the float bowl closes a needle valve when the bowl is full. It sounds to me that you may have a bad float or a bad needle valve. As stated before, buy the appropriate kits and floats and install them. For both outboards.
 

Arlan Jay

Cadet
Joined
Jun 28, 2014
Messages
13
Just rebuilt the carb today. New needle seat and new float. Was not sure about float adjustment but reassembled anyway. The fuel is not pouring out of the butterfly valve area, but out of a 1/4" hole just above that.
 

hopp49

Recruit
Joined
Jan 30, 2016
Messages
3
I have a 1995 175 fast strike and I'm looking to open the air and fuel flow! Ive turned the timing up to 25 thousands and would really like to go to 32 atleast but trying to find out exactly how far to open the fuel jets and/or air jets! I'm running it on an 89 winner legend which is a heavy boat with a 27 degree pitch 4 blade prop and only getting around 52 to 54 on a good day! So any help with my wanting more push would be very appreciated! THX MIKE
 

jbcurt00

Moderator
Staff member
Joined
Oct 25, 2011
Messages
25,353
Mike
Please take note of the tip at the top of the forum page and dont post in 90days+ inactive topics.

The carb on your Fast Strike is no where near similar to the 40hp SeaHorse carb this topic is about. Refrain from posting questions about your project in other members topics, esp questions unrelated to the topic at hand.

Arlan also hijacked this topic posting about his motor work and it should have been caught then.

As you've also started a topic about your fast strike, this topic is now

Closed
 
Status
Not open for further replies.
Top