johnson 9.9 milky fuel in combustion chamber

clairmarinelighting

Cadet
Thread starter
Joined
Apr 3, 2016
Messages
12
I will get a new one and install it...went out today and ran at a much higher rpm...put new plugs into it aswell...very very little milkynes on inside of combustion chamber....plugs were clean... no milkyness...I think your right oldboat1, with the tstat....thanks a lot guys...
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Oops. Had misread your earlier post -- thinking earlier that you had replaced it.

The easiest way to get in there (t.stat) is to pull the head, and then go after the thermostat -- probably know that from prior work. But in case you haven't removed the cyl head with the powerhead installed, need to leave the lower bolts loose in the head, then remove it (no room to back them out all the way).
 
Top