Johnson '82 60HP won't plane boat

JohnRoscoe

Recruit
Thread starter
Joined
Jun 30, 2003
Messages
4
Have this motor on a 16' Fiberglass Tri-Hull, but can't get the boat to plane. GPS says I'm only getting 6-7 MPH with throttle wide open. Motor sounds healthy at all RPMs. I would think that this would be plenty of motor for the boat, but it just isn't getting the job done. I am clueless as to where to look first. Any ideas?
 

Paul Moir

Admiral
Joined
Nov 5, 2002
Messages
6,847
Re: Johnson '82 60HP won't plane boat

If the engine is spinning up, but the boat isn't moving, it sounds to me like the propeller is slipping on it's hub. Mark the hub (part that contacts the propeller shaft) against the propeller (blade part). Then drive the boat and see if your marks still align. A spun propeller can be rehubbed at a prop shop. <br />Good luck!
 

Cricket Too

Lieutenant Commander
Joined
May 14, 2003
Messages
1,732
Re: Johnson '82 60HP won't plane boat

You said the engine sounds good at all RPM's, so I'm assuming your getting the revs out of it a wot and just not going anywhere. I agree with Paul Moir, sound like a spun hub, easy fix. Good Luck.
 

JohnRoscoe

Recruit
Thread starter
Joined
Jun 30, 2003
Messages
4
Re: Johnson '82 60HP won't plane boat

I can't get the prop to spin on it's hub? Any other suggestions of things I should look at?
 

Solittle

Fleet Admiral
Joined
Apr 28, 2002
Messages
7,518
Re: Johnson '82 60HP won't plane boat

Need to get the prop re-hubbed - - - thats three for three!
 

harley909

Cadet
Joined
May 25, 2003
Messages
21
Re: Johnson '82 60HP won't plane boat

Hi,<br />I would make sure the motor is firing on all cylinders and that there is gas getting to all cylinders. I have a Johnson 70hp that ran perfectly even on 2 of 3 cylinders. It would idle and go at trolling speed all day but would never plane out. Had one cylinder not firing and one plugged main jet in a carb. Once both were fixed it planed out.<br />I was utterly amazed how well the motor ran with one cylinder not firing.
 
Top