Johnson 60 VRO 1988 stalling on acceleration

westfinger

Cadet
Thread starter
Joined
Aug 6, 2017
Messages
10
Hi, has anyone experienced anything similar to this with a Johnson motor? I have to use the primer to get it going on every throttle up.
​Other than this is runs good (for a 1988 motor).
 

westfinger

Cadet
Thread starter
Joined
Aug 6, 2017
Messages
10
Just read about the OMC service bulletin about drilling 6mm holes in the prop. Worth a go I suppose??
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
If you have to hit the primer to get the motor going it sounds like a carb problem not a prop problem. Maybe a tear down and cleaning of the carbs is in order also a link and sync.
 

westfinger

Cadet
Thread starter
Joined
Aug 6, 2017
Messages
10
The story continues, yesterday I was out on the water and everything started fine but i noticed the engine started to loose power whilst on the plane. After stopping for a bit and setting off again 30 mins or so later the same again loosing power, so much so that I was nearly at full throttle to keep her moving.
​After getting worried about this I slowed to a troll and the motor started to sound rough, so I limped home. Not a good day.
​Been down today and the engine starts but misses and sounds really bad, hope you can get access to see the video I took. (https://youtu.be/aM6lkQUaSrg)

​I also took the spark plugs out and found they were oily and looked gritty, (not looking good to me)! Can anyone offer any hope for this engine?

​
 

westfinger

Cadet
Thread starter
Joined
Aug 6, 2017
Messages
10
Ok test done and I had 130psi on the top and bottom cylinder and about 20psi on the middle. Think I found the issue....
​Does anyone have any experience with stripping these motors down and the pitfalls? I just would like to know what i'm getting myself into and whether it is really worth the work. I got a service manual so have got step by step guide on what to do but i'm thinking parts, are they still available?
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
First take the head off and see if you have a blown gasket. If you have a factory manual you are good to go for info. Parts are very available you can get a complete rebuild kit for around $500. If you have to tear it down DO NOT remove the max timing screw under the front of the flywheel will make it easier to time when you put it together.
 

westfinger

Cadet
Thread starter
Joined
Aug 6, 2017
Messages
10
Thanks for the response. Head gasket check first of all then. I'll see if I can find the time to take that off tomorrow.
 

westfinger

Cadet
Thread starter
Joined
Aug 6, 2017
Messages
10
Went down but the 4 centre bolts for the head are tight in! Didnt dare give them to much as they were going to shear off. Any tips for getting them out?
 
Top