Johnson 40ES70A starts but stalls immediately after

CeaserLeo

Recruit
Thread starter
Joined
Jul 1, 2018
Messages
2
Hello, i have recently become the proud owner of a 1970 crestliner equiped with a 40hp electric start johnson outboard motor of the same year which i am hoping to restore. The hull and overall condition of the boat are in fantastic shape given the age of this beauty, however, i have thus far been unable to get the motor to run. The unit is able to start up via the igntion but stalls almost immediately thereafter. Initially the switch that makes contact with what i am assuming is the stop/shift lock, based on imagery, was coming lose from the body and breaking the connection effectively killing any means of ignition via the key, some loctite on the bolt that threads into the body to hold its bracket in place seems to have taken care of this issue. The solenoid have been replaced, spark plug replaced and gap set, carb cleaned as per a local mechanic whos work is a little dodgy at best given his lack of knowledge on older motors (the motor happens to be twice his age), and thus i am left trying to figure out what is going on myself. I have a fair amount of mechanical knowledge but outboard motors is a very new thing to me and any advice regarding this issue would be greatly appreciated. Thank you.

P.S. I have recently come to the knowledge that the fuel/oil mix is 50:1 and is best used with octane 87, i am unsure of the current mixture which is possibly 60:1 so i will be trying this out at the next opportunity i have to work on the motor.
 

Bosunsmate

Admiral
Joined
Apr 7, 2012
Messages
6,135
Check compression and also what your spark is like, can it jump a 7/16 gap.
If thats ok will need to figure out if its getting fuel properly
And yes 50/1
 

CeaserLeo

Recruit
Thread starter
Joined
Jul 1, 2018
Messages
2
Hello bosunsmate, thank you for your response. With regard to spark, i have a strong spark and compression seems good. The fuel was an issue prior and i have replaced connectors as they were not functioning properly. I have a solid ball and fuel comes out the basin screw, is it possible the fuel oil mixture if not correct could cause this problem
 

Bosunsmate

Admiral
Joined
Apr 7, 2012
Messages
6,135
mixture wouldnt cause that issue. Ground your spark plug wires then use the starter to turn the motor over a few seconds. then remove the spark plugs and check they a wet with fuel. Light it to check its fuel and not fuel mixed with water which wont light
 
Top