Johnson 28 spl not getting full throttle

Angler96

Recruit
Thread starter
Joined
Jun 17, 2018
Messages
3
Started about a week ago. I go out fishing almost everyday. It started running a little weird noticed a little less power. Then the next day it was running better and faster than it ever has. Since then I have only been getting barely half throttle. In idle with the choke up it will rev high, it will also rev high in reverse. But in forward I get no power whatsoever, won’t even get on plane. Changed the spark plugs, put a new fuel line in from the tank to the motor, made sure the vent on the tank was working properly, ball is hard when running, tried running a can of sea foam thru it.. after all that still the same issue, any help is greatly appreciated!!
 

Angler96

Recruit
Thread starter
Joined
Jun 17, 2018
Messages
3
Also want to add that I am not very familiar with any outboards, never really had to take one apart but I’m good with my hands just looking to get info on where I should start, thanks
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Might have gotten a dose of bad gas — check for water.

See if the lower carb needle (high speed air/fuel) has shaken loose. Should be about 3/4 turn open from seated (counter clockwise to open). Maybe richer (c.clockwise) or leaner for best operation. The nut holding the needle in place should be tight enough to keep it from vibrating loose, but not so tight that you can't adjust the needle.

To see if you are dropping a cylinder, pull off and replace plug boots one at a time. If you get no change when pulling off a boot (rpm change or stalling), that plug is probably not firing (ignition issue, not a plug issue — may need to clean and reset points).
 

Angler96

Recruit
Thread starter
Joined
Jun 17, 2018
Messages
3
I pulled the top boot off the plug at idle, no change, I pulled the bottom boot off the plug at idle, wanted to stall out
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Top one is suspect. Would use and adjustable spark tester, and see if you have spark (if some spark, measure it and note intensity -- should be sharp. Some crackle is good.)
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
No high speed mixture needle on a 28 HP SPL .--No points on it either.---Check compression.-----Check for spark.----Has impeller been replaced recently.---Motor could be overheating too.
 
Top