Johnson 25Hp tiller shafts and gears

TommyTue

Recruit
Thread starter
Joined
Aug 4, 2016
Messages
2
I have a 25hp Johnson, 75 model I believe with a pull start. I've been looking for instruction on the assembly for the gears in the tiller. Specifically the gears that are on the engine that mesh with the throttle arm that's bolted to the engine block. When I twist the throttle to full power it doesn't open the butterfly and when I twist it further is disengages, gear slips. I've looked around the net and have yet to find a description/instructions to set it. No teeth are missing from either gear. I'm at a loss :(

What I'm working on are parts 109 and 52 in the diagram
 

Attachments

  • 2009-06-05_003406_5.png
    2009-06-05_003406_5.png
    42.7 KB · Views: 0
Last edited:

gm280

Supreme Mariner
Joined
Jun 26, 2011
Messages
14,605
I have a 25hp Johnson, 75 model I believe with a pull start. I've been looking for instruction on the assembly for the gears in the tiller. Specifically the gears that are on the engine that mesh with the throttle arm that's bolted to the engine block. When I twist the throttle to full power it doesn't open the butterfly and when I twist it further is disengages, gear slips. I've looked around the net and have yet to find a description/instructions to set it. No teeth are missing from either gear. I'm at a loss :(

What I'm working on are parts 109 and 52 in the diagram

:welcome: Tommy Tue to iboats. Nice to have you join us...

Those gears only mess and move so far. So if the tiller handle was ever removed, either by you or the pervious owner, is could be it wasn't installed back correctly. If you watch the gears and how they mesh together, you will see where they have to be to get the proper range. So take a good look at the tiller handle gear and were it meshes with the throttle gear and see if it is correct to allow full throttle and idle as well. A good place to start is with both the tiller handle at the slowest position and the throttle gear at the same lowest position. Try that and report your results. JMHO
 

TommyTue

Recruit
Thread starter
Joined
Aug 4, 2016
Messages
2
dogs.JPG Problem solved and ya know sometimes you just have to call yourself an idiot. I got all the gears cleaned, lubed and reinstalled. But when I gave it full throttle it wasn't pushing the timing plate around far enough to reach the ramp that opens the carb. {Pulled the throttle shaft out and then it dawned on me...................there were no dogs in the lower side of the throttle shaft. The good thing is it's a small piece of plastic that presses in, the bad part...........it's a small piece of plastic that will leave you only able to idle, I got a spare for the tackle box.
 
Last edited:

AlTn

Commander
Joined
Mar 9, 2010
Messages
2,813
that pin can be gremlin..one ear can crack and jam the mechanism....it can get dislodged, left out ,etc.
 
Top