Johnson 25 killswitch not turning motor off

Ncsaltydog

Cadet
Thread starter
Joined
Aug 14, 2017
Messages
6
I finally put my new 2002 Johnson 25hp i bought in the water today to test it after a new prop and impeller. Once I ran it around and hauled butt around the river, I pulled up to the shore and pulled the safety clip out to shut the motor off and it kept running. I lowered the rpms until it bogged out and shut off (assuming carb emptied of fuel). When I go to restart it I have to pull and pull a million times to get fuel to it to get it cranked back up again. Is my kill switch bad? Wire not connected possibly? It?s a lanyard kill switch..Thanks guys!!
 
Last edited:

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Trace the wires from the kill switch -- should find one of them goes to a single amphenol connecter coming off the power pack, and a second one connected under one of the ignition coil mounting bolts. They are black wires running under the powerhead from the front of the motor. First see if one of the wires is loose. If not, test continuity at the end of the leads. Should see no continuity when the clip is inserted, continuity when the clip is pulled.

Not sure about the starting/restarting issues -- could be related to the kill switch if the switch or connection is wonky. Could be an issue with the primer, or with starting procedure.
 

Ncsaltydog

Cadet
Thread starter
Joined
Aug 14, 2017
Messages
6
Thanks oldboat1.. I will do some tracing tomorrow on those 2 wires. Once i came to a stop it kinda bogged down from me dropping the idle down to Low idle/shift. It was the only way to get it to cut off.

Also is there a way to tighten anything to where my motor isn’t soo loose swinging left to right? It’s killing my arm and hand holding it soo tight going straight? I need it a little more stiff, steering is VERY loose feeling. Thanks!
 

Ncsaltydog

Cadet
Thread starter
Joined
Aug 14, 2017
Messages
6
On the inside of the motor there is maybe 3 colored wires that look like it was once hooked up to some electronics controls that are just sitting there unplugged. I?ll add those 2 screws to my list for tomorrow to look into and tighten. Thanks again oldboat1!
 

Ncsaltydog

Cadet
Thread starter
Joined
Aug 14, 2017
Messages
6
I also need to fill an oyster bag with sand to weight my front end down with all this power! I had a ?75 merc 9.8 hp on it and now this 25 is a beast!
 
Top