Johnson 150 gt v6 (86 ranger)

fireside286

Recruit
Thread starter
Joined
Aug 11, 2016
Messages
3
Hello, I bought this ranger and looked in the engine compartment and this plug isn't plugged in. Should I plug it in or could someone tel me what it does? Thanks
 

Attachments

  • image_106209-1.jpg
    image_106209-1.jpg
    48.1 KB · Views: 0

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
Looks like a pair of brown wires. Those may be part of the overheat switch circuit/vro oil warning system. Think I'd want them connected.
 
Last edited:

fireside286

Recruit
Thread starter
Joined
Aug 11, 2016
Messages
3
EMD, thanks for the reply. The guy that I bought it off of said that the system for oil was removed and that I needed to premix the gas. So if this is what it is maybe it won't need plugged in. I only Houghton maybe it went to a coil pack. The wires are brown and brown/yellow.

Thanks again for the help.
 

fhhuber

Lieutenant
Joined
Jun 19, 2014
Messages
1,365
Trace the wires a bit.

If one side of the plug set leads to the fuel pump its the VRO low oil flow alarm. If plugged in that alarm will be very annoying with the VRO oil injection disabled.

There are other very similar looking plug sets with different numbers of and colors of wires in that engine. VRO plugs (when using pre-mix) and the plugs for remote tilt/trim + tach can be disconnected and the engine will run. The others being unplugged it won't run.

Tilt/trim on the side of the engine works if the plug for the remote (usually on throttle lever) +tachometer is unplugged.
 

Faztbullet

Supreme Mariner
Joined
Mar 2, 2008
Messages
15,938
VRO plugs are 3 or 4 wire connectors and never brown or brown /yell...
 
Top