Johnson 10 horse stuck in reverse and leaking gas

MikeReimer

Recruit
Thread starter
Joined
Jun 14, 2003
Messages
3
Hi there,<br /> Just bought a 1971 14' crestliner with a Johnson Seahorse 10 hp motor QD-21 s, #2113883<br />Took it out and it started fine...then began running rough. I figured because there was maybe 1/4 gallon of old gas in the tank. I added gas/oil mix till full and mixed 50:1. Tried to open it up all the way at high speed and it was a dog. Then I ran it in reverse a little because weeds were getting tangled on the prop. Now she is stuck in reverse. Brought it home and noticed a green foam on the garage floor below the prop. smells like gas. whats with the green?? weed leftovers perhaps?<br />thanks for any info as im a boating newbie :(
 

Bear

Lieutenant Commander
Joined
Mar 1, 2001
Messages
1,627
Re: Johnson 10 horse stuck in reverse and leaking gas

QD-21 is a 1960 model. Picture <br /><br />Remove the prop and remove more weed. Check the prop shaft sealing. Also check the oil in the lower unit. Get new oil and sealings for the oil plug and oil level plug.<br /><br />I think you have to clean your carb too.<br /><br />Fuel mix is 24:1 I think. Not 50:1. <br /><br /> http://www.iboats.com/boatproducts/mallsearch/johnson_outboard_manual/
 

MikeReimer

Recruit
Thread starter
Joined
Jun 14, 2003
Messages
3
Re: Johnson 10 horse stuck in reverse and leaking gas

thanks Bear,<br />I did take off the prop and looks like all the weeds are gone...not sure where to check the oil on the lower unit (my first boat and motor) but I have a manual on the way :) <br />nice pic by the way thanks
 

wayne h

Master Chief Petty Officer
Joined
Apr 29, 2003
Messages
862
Re: Johnson 10 horse stuck in reverse and leaking gas

the green is the fuel oil mix.i always fun 50:1 in my engine.you really need to wait for the manual and read it from cover to cover.there is alot of good info in there and on this forum. i am a newbie and have learned a ton in the last few weeks. i had to totally go though my engine.even all the stuff the guy told me was new when he sold it to me.i replaced my water pump,points,coils,wires,plugs,all the lower end seals because when i drained the lower end it was milky looking,decarbon the engine,rebuilt the pull cord.also look on ebay for a service manual just for that engine.my engine is a 1972 evinrude 9.5 i knew nothing about boats when i bought this 1. if i did i would never have bought it haha. with a good manual you will be ok.the older engines are not really that hard to work on and parts are pretty easy to get still.with all that said welcome to the MONEY PIT lol a boat is a hole in the water that you throw money into.but once on the water there is no better place to be.
 

MikeReimer

Recruit
Thread starter
Joined
Jun 14, 2003
Messages
3
Re: Johnson 10 horse stuck in reverse and leaking gas

Just got my manual in the mail and am in the process of rebuilding the lower end...without the manual Id be lost. Fun tho :) thanks for all the help
 
Top