I've made a terrible, terrible mistake . . .

paddy1998

Recruit
Thread starter
Joined
Oct 3, 2016
Messages
1
I have a 1966 3hp Johnson Seahorse (JW-21) that I was replacing the carburetor gaskets, float, float valve and seat, etc. It was going well (I haven't done this kind of thing before but I had detailed instructions that I understood clearly) until I tried to remove the old float valve seat. It just wouldn't budge, and I over torqued it and SNAP! That so%#@%ch broke off!

Now, you might think that this is the terrible, terrible mistake that I was talking about. But you'd be wrong. Here's the REALLY bad part: I tried to drill out the remainder of the seat, and in doing so completely wiped out the threads.

What the heck can I do now? Can I plug it and then tap the correct threads? JB weld the new valve seat in? Throw the whole carb out?

I really don't think I've ever been so angry at myself . . .
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
That's a tough one. Might be better off finding another carb body. I can look through my junk pile - good chance I've got one somewhere... Drop me a PM...
 

gm280

Supreme Mariner
Joined
Jun 26, 2011
Messages
14,605
I have a 1966 3hp Johnson Seahorse (JW-21) that I was replacing the carburetor gaskets, float, float valve and seat, etc. It was going well (I haven't done this kind of thing before but I had detailed instructions that I understood clearly) until I tried to remove the old float valve seat. It just wouldn't budge, and I over torqued it and SNAP! That so%#@%ch broke off!

Now, you might think that this is the terrible, terrible mistake that I was talking about. But you'd be wrong. Here's the REALLY bad part: I tried to drill out the remainder of the seat, and in doing so completely wiped out the threads.

What the heck can I do now? Can I plug it and then tap the correct threads? JB weld the new valve seat in? Throw the whole carb out?

I really don't think I've ever been so angry at myself . . .

Okay I have to admit, that is bad news. Depending how bad the drilled out area looks, you could install a solid metal plug and redrill it for the seat. It is delicate work and maybe a machine shop could do it better, but at this stage what do you have to lose. JMHO
 

kbait

Commander
Joined
Nov 13, 2007
Messages
2,488
Call tim's outboard 218-682-2331. They'll most certainly have a used carb and you can just swap it out.
 
Top