I have some raw water plumbing to re-do. Since there are a few "complex" runs I was doing some brainstorming and I remembered helping a friend assemble some braided stainless hoses for a car build. So I thought to myself... why not use that in lieu of the tried and true hose barb and double hose clamp? If the performance/racing car crowd trusts them to hold 15 PSI coolant, 100 PSI engine oil, etc I don't see why relatively low pressure raw water would be a problem.
Anyone know if this goes against best practices? Can't say I've ever personally seen it on any type of watercraft, but that very well could be due to the fact that the money spent on stainless fittings (I would not use aluminum) and hoses for one run would probably buy a lifetime supply of rubber hose and hose clamps. However, the gains in longevity, durability and ease of use (no more busted knuckles trying to pull a hose off of a termination!) would be huge advantages in my mind.
Some examples of what I'm talking about for those not familiar:
http://anfittingguide.com/install-ptfe-hose-fittings/
https://www.pegasusautoracing.com/group.asp?GroupID=PTFEHOSE
Anyone know if this goes against best practices? Can't say I've ever personally seen it on any type of watercraft, but that very well could be due to the fact that the money spent on stainless fittings (I would not use aluminum) and hoses for one run would probably buy a lifetime supply of rubber hose and hose clamps. However, the gains in longevity, durability and ease of use (no more busted knuckles trying to pull a hose off of a termination!) would be huge advantages in my mind.
Some examples of what I'm talking about for those not familiar:
http://anfittingguide.com/install-ptfe-hose-fittings/
https://www.pegasusautoracing.com/group.asp?GroupID=PTFEHOSE