Impeller Help!

Bgladu

Recruit
Thread starter
Joined
Oct 2, 2016
Messages
3
I am stumped! Tried replacing impeller and water pump housing on a 1982 or 1985 evinrude 25HP and something went wrong. I thought I had it all together correctly, it was spitting water for about 10 seconds then stopped. I took it apart again, and the impeller was trashed... See picture. What could I have done to cause this issue? Thanks in advance!
 

Attachments

  • image.jpeg
    image.jpeg
    264.3 KB · Views: 0

Hennysemitara

Petty Officer 2nd Class
Joined
Aug 4, 2016
Messages
175
Woah that impeller is bad did u run it woth water
 
Last edited by a moderator:

Bgladu

Recruit
Thread starter
Joined
Oct 2, 2016
Messages
3
Yeah real bad! I had it in a barrel. The water went over the water intake so I figured it would be good.
I used an o-ring to hold the lock key on the shaft as I saw in a video, but don't remember that from when I took it apart. Is that the correct way to install it?
 
Last edited by a moderator:

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
You need to have the water above the waterpump housing if you run it in a barrel. I usually just use vaseline to hold the key in place little dab works good then put the impeller on. When I put the housing on I just lube that with dish soap, then press the housing down on the impeller and turn the driveshaft to the right while doing that and it will pop on. That does 2 things it makes sure the key is in and orientates the vanes correctly.
 

Scott Danforth

Grumpy Vintage Moderator still playing with boats
Staff member
Joined
Jul 23, 2011
Messages
53,424
As stated above, water has to be pretty high up (so the raw water pump is submerged)

Were you running it in a garbage can or a 5 gallon bucket? I suggest muffs next time
 

Grub54891

Admiral
Joined
Jun 17, 2012
Messages
6,494
Make sure the housing is in good shape, when they get that hot the housing cup may have slipped,( If it has one) Make sure the housing is deep enough and the intake is clear.
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
I would guess the intake is pluged or you have the base plate on upside down or wrong kit.
 
Top