impeller backwards?

merleti

Recruit
Thread starter
Joined
Jun 28, 2010
Messages
3
I put in a new impeller(90 Yamaha outboard) and didn't even think to see if I put in in the correct direction. At first when I hooked it up only a little water came.I ran it for 10 sec or so. After searching it seems there is different schools of thought.

One "it will correct itself" and another "never do that".

When you put the motor in reverse isn't the impeller going to spin backwards or the opposite direction?
 

Expidia

Commander
Joined
Aug 26, 2006
Messages
2,374
I personally don't think it makes any difference. The fins will conform to the proper direction as soon as you start the OB. More important is you are supposed to lube the inside of the housing a little, so the rubber does not tear when you start it up in a dry housing.

I doubt that the water pump changes direction when in reverse. Never thought about that question :confused: but I highly doubt it.
 

Expidia

Commander
Joined
Aug 26, 2006
Messages
2,374
Duplicate post . . . . Shocker :jaw:
 
Last edited:

99yam40

Fleet Admiral
Joined
Sep 7, 2008
Messages
9,375
it will not fix itself.
Drop it and make sure you do it right this time
 

Expidia

Commander
Joined
Aug 26, 2006
Messages
2,374
I stand corrected by this article. It does mention there is a side up when installed correctly. The firstf one I changed myself on an older OB made no difference. The last two times my Merc 40 was changed it was done at a Merc shop. Article also mentions the lube with a little dish soap before closing the pump cover.

http://johanramakers.hubpages.com/hu...ard-Water-Pump
 

TD_Maker

Chief Petty Officer
Joined
Aug 31, 2005
Messages
564
The impeller spins only in one direction...at all times. The gearcase makes the prop spin backwards. When seating the rubber impeller, note that the shaft spins clockwise, so the rubber splines will face in the other direction. The dish soap lube works great...I have also used Vaseline.
 
Top