Ignition issues on my 135

rodknee1231

Petty Officer 2nd Class
Thread starter
Joined
Jul 28, 2015
Messages
136
So last year I put away my 17ft sea sprite with a 1973 evinrude 135 without figuring out what was wrong with it. I had lost and sometimes had intermittent spark on 4 cylinders almost if it wasn't cranking fast enough. I was using a deep cycle battery to crank with. It ran fine earlier in the year but started having issues and I never had the time to mess with it. I seem to remember it having the proper amount of volts. Also ruled out my triggers as the list spark never seemed to follow when I swapped trigger wires. Stator isn't melted and problem never followed coils either
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
You'll want to check the test procedures for both the stator and the timer base. Per the guide listed #2, above.
 

rodknee1231

Petty Officer 2nd Class
Thread starter
Joined
Jul 28, 2015
Messages
136
I just dug the boat out. Knowing it had gotten put away with a spark issue. I just 4 brand new coils on it because only 1 had ohm resistance. So I put my inline test light on the spark plug wires and had nothing on all 4. So I pulled a spark plug and held it against the head and hd the wife turn it over and it had a great spark. But I got zapped on my other hand touching the frame. She also got zapped through the key. Neither have happened before. Perhaps I have a bad ground ? All of the seem ok but old. Should rerun all the ground wires ?
 
Top