I need help identifying an outdrive

[bluecollerboater]

I have a new to me boat with a volvo penta duoprop. I removed the tag on top of the upper gear case but can not make out what numbers are on it. What I do know is on the flame arrestor cover it has a sticker that says transom assembly DP-S (290) then two sets of numbers:
4111522228
3868299
Behind the engine on the inside of the transom assembly it has a tag that says DP-S.
And last it says SP in big stickers on the back of the drive. I have four more pics but it would not let me load them. I guess they were to big. Thanks in advance for any help it is a new to me boat. I want o check the u joints and gimbal bearing but want the parts before I rip into anything.

 

[Don S]

Re: I need help identifying an outdrive

Should be a tag on your drive shown by the arrow in the picture below.

 

[bluecollerboater]

Re: I need help identifying an outdrive

I took that tag off Today. I could not make it out. I am looking at it now and all I can make out is DP-, I can not make out any more. It is in a 1995 carver 250. Originally it had a Volvo 5.7 Gi now it has a 1987 mercruiser 260. The PO told me he had it changed out two years ago. The only reason I know it was originally a 5.7 Gi is the flame arrestor cover from the Volvo is still on there. He replaced the motor with the mercruiser but switched over all the accessories. Alternator, water pump(raw water cooled) etc.

 

[bluecollerboater]

Re: I need help identifying an outdrive

Also the tag wasn't stamped. The numbers seemed to be scratched in.

 

[Don S]

Re: I need help identifying an outdrive

If it was a 95, it would be a DP-C1 drive, could be just a C. Doesn't really matter any more, the things that have changed from the C to the C1 through D models are all the same now.

 

[bluecollerboater]

Re: I need help identifying an outdrive

So when I look for parts or a manual this drive would be a DP-C1 is that correct?

 

[JaseBosto]

Re: I need help identifying an outdrive

If it was a 95, it would be a DP-C1 drive, could be just a C. Doesn't really matter any more, the things that have changed from the C to the C1 through D models are all the same now.

If appears that, that would be the case IF its a 95....If the drive was replaced....

 

[Don S]

Re: I need help identifying an outdrive

If appears that, that would be the case IF its a 95....If the drive was replaced....

It would have been that if it was OEM, not replaced.

 

[JaseBosto]

Re: I need help identifying an outdrive

I shouldve finished my sentence. I was hinting that, if it was replaced, who knows what it is..