HydroElectrc Shifter

comrad.12357

Cadet
Thread starter
Joined
Jul 8, 2012
Messages
8
I have a 1970 85hp HydroElectric Johnson, its in great shap other than it won't shft properly.
I was going through my service manual, and I found that changing the oil in the lower unit might help.
I tried that, and it did actually work, but it was temporary, very shortly after it decided to quit again, upon draining the oil i found that the new oil was milky like the oil I had already drained from it earler. This leads me to believe that maybe a leak in the lower unit is causing the shiftng problems. I've nspected the lower unit for cracks, however couldn't find any.

So, my question is:"Where could my lower unit be leaking from, and if this isnt the cause then what else could be?"
 

mstahl1171

Petty Officer 1st Class
Joined
Mar 16, 2010
Messages
209
Re: HydroElectrc Shifter

Common problem and easy fix. more than likely it is the prop shaft seal. You can order all the seals from here on iboats. Make sure you replace the drive shaft seals and prop shaft seals. Also the seals for the fill and vent crews...Super easy job to do. I did my 40hp Evinrude last year...cost me around $40 in parts and a few hours to do. Your service manual should have all the part number. Don't go by the Seloc manuals...make sure you use a factroty manual.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Re: HydroElectrc Shifter

Water can leak into the oil via the following.----Driveshaft seals under the water pump.-----Propshaft oil seals.---Gasket for the shift solenoids.--O-ring on the propshaft bearing carrier and thrust bearing carrier. --- 4 wee o-rings on the screws that hold the propshaft bearing carrier.---Also the washers on fill and vent screws.
 

Joe Reeves

Supreme Mariner
Joined
Feb 24, 2002
Messages
13,262
Re: HydroElectrc Shifter

(Checking Gearcase For Leaks)
(J.Reeves)

Remove the large slotted drain/fill screw from the bottom of the gearcase and also the identical looking screw that will be located up near the cavitation plate in order to drain the gearlube.

After all of the lubricant has drained, install one of the slotted screws, whichever your preference might be.

Apply 7 to 12 pounds of air pressure to the open screw hole. Use a piece of rubber fuel line or something to create a tight air hose fit if you do not have a proper fitting.

If a leak exists, that pressure should allow you to locate the leak by sound and/or sight.
 
Top