how to replace heat sensors 98 150 intruder

[gary1985]

can someone tell me how to replace these do you have to pull the heads off
and other then watching it doesn,t over heat can i safely run it with them disconnected until i get new ones.

 

[Chris1956]

Re: how to replace heat sensors 98 150 intruder

The heat sensors have a cover. Remove the cover and pull them out.

Are yours bad? Have you tested them? They are not cheap, especally the Quickstart Sensor ($99)

 

[gary1985]

Re: how to replace heat sensors 98 150 intruder

thanks again chris yes i took the the boat out and ran it with them unplugged and it was fine plug them back in and it drops back down to 2200 rpms so i guess that means they are screwed up i put my hand on the block it was not hot at all

 

[Chris1956]

Re: how to replace heat sensors 98 150 intruder

Since there are two sensors, I recommend you test each of them to see if one is still good. That could save some $ if only one is bad.

 

[gary1985]

Re: how to replace heat sensors 98 150 intruder

thanks again Chris I only replaced one ,the expensive one was shot and you were right $98. the other is only $55