Hour gauage Fault

Mike 1961

Recruit
Thread starter
Joined
Feb 25, 2009
Messages
1
I have an digital hour gauage on my boat a Jeanneau Leader 805 with a Volvo Penta KAD 43 engine. Just recently the gauage failed to display the hours. Can anyone tell me if this is a minor fault that I can fix? I am handy with mains electricty and have a fair knowledge of 12V Dc. Mike
 

BaileysBoat

Senior Chief Petty Officer
Joined
Sep 29, 2008
Messages
716
Re: Hour gauage Fault

Determine if it's the gauge or wiring. Power and ground ok?

Basically these these are electronic clocks
 

cbavier

Lieutenant
Joined
Apr 8, 2007
Messages
1,363
Re: Hour gauage Fault

Check the wires at the ignition switch. Most hour meters are wired to the ignition switch. One may be broken or have came off or loose. Make sure you disconnect the battery cable before you mess around with it too much. On mine each wire has a screw.
 

pvanv

Admiral
Joined
Apr 20, 2008
Messages
6,590
Re: Hour gauage Fault

Chuck and Bailey are completely right. It's a 12v "clock" that runs when powered up, stops when powered down. Typically energized from the ignition switch or relay. If it has 12v when the motor's on, and is still not running, it's time for a new one. Replacement units (if needed) are affordable, most of them under $100.00.
 
Top