Hot tell tale and Alarm

Indureiner

Recruit
Thread starter
Joined
May 1, 2010
Messages
4
Hi
I have a 50HP 4stroke Evinrude 2001. Problem is that tell tale gets very hot and alarm goes off (long beep). This can happen straight away or after running the engine for ? an hour and then going into idle. I have replaced Impeller and housing, New Thermostats and did a general clean with some cleaning fluid, Nothing changed the issue. I was told by my motor guy that it could be a small leak in the head gasket heating up the cooling water. But he dident do a compression check, and ddident want to change the gasket ( He got health issues, he is excused :) )
Should i pursue this line going for a quite large operation changing the Power head gasket, or is there any other solutions i should be aware of? Any ideas and help is highly appreciated
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
I picked up one of these motors for cheap some time ago.--------Severe overheating scrapped it.--------Melted the many plastic parts .---Even melted timing chain tensioner under the block.-------So call around to a dealer that is familiar with this Evizuki motor.-----There is a great risk of doing severe damage if overheating is not corrected.
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Have you owned it since new? Has an impeller come apart? Might.need.to be back flushed. Water flow diagram is in manual.

Is it a.salty dog?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Perhaps contact ----Brown's Point Marine.------SUZUKI folks.
 
Top