HOLE IN BLOCK!

Dcraine

Recruit
Thread starter
Joined
May 30, 2017
Messages
1
What's up guys I have a 1975 70hp Evinrude that blew a hole in the block last summer.. I have found an 1984 Evinrude 70hp powerhead with good compression for sale. Will the 1984 work on the 1975? Any help would be awesome! I checked the diagrams and most of everything looked the same gasket wise but some small details were different. Is this a big deal?
 

gm280

Supreme Mariner
Joined
Jun 26, 2011
Messages
14,605
:welcome: aboard Dcraine to iboats....

So basically you are looking to install your lower unit on the newer power head. Is that correct? If the gaskets seem to be the same, then the mounting hole has to be as well. I haven't checked, but that would seem like a go. But maybe others with more knowledge can chime in and verify one way or the other. JMHO
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
Different shift patterns - make sure you use the 1975 shift and throttle bits on the 1984 powerhead. Otherwise, I can't think of any reason why it wouldn't work. '84 is a much improved powerhead, too - beefier rods to prevent just such an issue.
 
Top